moulding
英 [ˈməʊldɪŋ]
美 [ˈmoʊldɪŋ]
n. 线脚(用于檐口、门楣等的凹凸带形装饰)
v. (用模具)浇铸，塑造; 对…影响重大; 将…塑造成; (使)紧贴于，吻合
mould的现在分词
Collins.1 / BNC.12354 / COCA.44053
牛津词典
noun
- 线脚（用于檐口、门楣等的凹凸带形装饰）
a decorative strip of plastic, stone, wood, etc. around the top edge of a wall, on a door, etc.
柯林斯词典
- (墙壁顶端或门框周围作装饰用的)嵌线，线脚，壁带
Amouldingis a strip of plaster or wood along the top of a wall or round a door, which has been made into an ornamental shape or decorated with a pattern.
in AM, use 美国英语用 molding
英英释义
noun
- a preliminary sculpture in wax or clay from which a finished work can be copied
- sculpture produced by molding
- a decorative recessed or relieved surface on an edge
- a decorative strip used for ornamentation or finishing
双语例句
- Mark the distance between the logo and moulding on the doors.
标记徽标和车门上的饰条之间的距离。 - The fibre orientation of short fibre reinforced complex material in injection moulding was summarized.
阐述了短纤维增强复合材料在注射成型中纤维的取向问题。 - The moulding process of rhombic honeycomb paperboard in laboratory was presented in detail.
介绍了一种在实验室条件下制备菱形蜂窝纸板的工艺方法。 - Raw bamboo fibers reinforced polylactide biodegradable material was prepared by means of non-woven method and moulding pressing technology.
以竹原纤维、聚乳酸为原料，采用非织造结合模压成型工艺制备了完全可降解材料。 - The moulding of the case utilizes the technology of full-vacuum braze welding for satisfying the sealing requirement.
为更好的满足密封要求，机箱采用了整体真空钎焊技术进行制造。 - The technological process, principles and the key points of technology controlling of the thermosetting plastic by using the fusible core injection moulding were described.
阐述了用可熔型芯注射成型热固性塑料的工艺过程和原理、工艺控制要点。 - This paper analyses the technological process of moulding sand compounding, and con-trolled by PC, then yields good results.
本文分析了型砂配制的工艺，用PC对其进行了控制，获得了良好地控制效果。 - The composition of HAAKE torque rheometer and its application to polymer moulding were introduced.
介绍了HAAKE转矩流变仪的系统组成及其在高分子材料成型加工中的应用。 - Yes, I have double checked the moulding material specification.
是正确的，我查过了它的材料物性表； - Care shall also be taken not to damage moulding and arris edges.
同时，应注意不要损坏模缘和斜边。